How to Find (and Fix) Low Water Pressure Problems in Your House

Cooking, washing dishes and bathing are all part of it Everyone difficult when Her water comes out of the faucet in a trickle. While you might think that low water pressure would be to solve a very complicated problem, it can actually often fixed with a few simple fixes. The trick is finding the cause of your water pressure problems first; the helps you determine how big the problem is and whether you need to call in experts. Here’s where to start.

Check with your water company

if Water pressure has dropped Throughout the home, the first call should be to your local water utility. Please check your site or give them a phone call to find out if there is a flush or repair going on in your area. Sometimes when there are problems with the water line, your water pressure can be temporarily affected.

If it doesn’t and there’s no obvious flooding, do it some other basic checks before you throw in the towel and call a plumber.

Check all valves

Low water pressure can be caused by a partially closed valve. This is by far the easiest thing to address. Starting with the water meter, which is usually outside yours home on one outer wall or under a covered hole on your curb, check to make sure the valves are open. If the valve has a lever, it should be parallel to the pipe. If it’s partially closed, this could be the answer to your problem. Then check the valves in your house. There has to be a master shut off valve somewhere Basement, utility room or near a washer dryer hookup. This valve is either a lever shape like your outside shut off, or a knob. Turn the knob counterclockwise or turn the lever parallel to the tube to open things. If the water pressure problem is localized to a faucet, check the shut-off valves there, which are usually located under the sink.

Check for leaks

If valves are not your problem, you could have a leak. This problem will be obvious if there is one Moisture or puddles of water where it doesn’t belong, but sometimes you can have a slow leak from a small crack that’s harder to see. one You can determine this by reading your water meter while all faucets and water-using appliances are turned off. keep them away tThen take another reading in a few hours. If additional water consumption is recorded, then you have a leak somewhere.

Look around everywhere you can think of (and a few places that don’t make sense) for moisture and water damage. Once you’ve found a slow leak, you might be able to patch it yourself, provided the problem is small. You can find one at most hardware stores pipe repair kit or Plumber’s Epoxy that can care emergency repairs. Once your repair is done, you should still have a plumber doing a professional jobbut a temporary patch can do that save yourself paying a plumber’s emergency rates.

Fix other issues

Once the most common problem areas have been ruled outconsider whether it can be too much need for water going into the house, which can be mitigated by alternating water for dishwashers, laundry and showers so they don’t overlap. Another common cause of low water pressure is mineral buildup in your pipes, which can be loosened by treating with vinegar or by flushing a professional plumber. This is more common in “hard” water areas where higher concentrations of minerals such as calcium are present in the drinking water.

Descale your water pipes

To “descale” or flush your own pipes, turn off your water heater or On a gas water heater, turn the flame setting to the pilot light, then turn off the water valve that goes into the water heater. CConnect a garden hose to the valve at the bottom of the water heater tank and drain about two gallons of water. Close the valve and pour a two-gallon pitcher of vinegar back into the top of the tank. Switch the tank back to its default settings and then let it sit over night.

Run all yours in the morning hot water taps for a few minutes. If your water pressure isn’t restored after this type of flush, it’s time to call a professional; The buildup in your pipes could be due to this Corrosion rather than mineral deposits which may require replacing some pipes (sorry).